The Ultimate Cheat Sheet on 메이저사이트

In studying to your CCNA exam and planning to earn this precious certification, you may well be tempted to spend minor time finding out static routing and head ideal for the greater interesting dynamic routing protocols like RIP, EIGRP, and OSPF. This is often an comprehensible blunder, but still a oversight. Static routing will not be complex, but it really’s a vital matter around the CCNA Test and also a precious skill for actual-globe networking.

To generate static routes over a Cisco router, 먹튀검증사이트 you use the ip route command followed by the place community, community mask, and possibly another-hop IP tackle or maybe the regional exit interface. It’s crucial to keep that very last section in mind – you’re both configuring the IP deal with from the downstream router, or even the interface around the community router that could serve as the exit interface.


Permit’s say your neighborhood router contains a serial0 interface by having an IP deal with of two, and the downstream router that would be the subsequent hop will receive packets on its serial1 interface using an IP tackle of The static route will be for packets destined for your network. Either of the following ip route statements would be suitable.

R1(config)#ip route (upcoming-hop IP handle)


R1(config)#ip route serial0 ( neighborhood exit interface)

It's also possible to create a static route that matches only one spot. It is a host route, and has for any mask. If the above mentioned static routes need to only be utilized to deliver packets to 172.ten.1.1., the next commands would do The task.

R1(config)#ip route (next-hop IP address)

R1(config)#ip route serial0 ( area exit interface)

Ultimately, a default static route serves토토사이트 as being a gateway of final resort. If there aren't any matches for just a desired destination during the routing desk, the default route will be applied. Default routes use all zeroes for each the vacation spot and mask, and again a subsequent-hop IP deal with or local exit interface can be employed.

R1(config)#ip route two (upcoming-hop IP address)

R1(config)#ip route serial0 ( area exit interface)

IP route statements seem uncomplicated plenty of, but the small print regarding the upcoming-hop IP deal with, the regional exit interface, default static routes, along with the syntax in the command are critical for success on CCNA exam working day As well as in the true planet.